Sealing and Joining
- Soldering cannot be used on aluminium-zinc materials; use only neutral cure silicone rubber or MS polymer sealants.
- Pre-align the pieces to be joined and pre-drill if possible.
- Thoroughly clean off surplus sealant and swarf using a dry, lint-free cloth or plastic scraper.
- Apply two beads of sealant close to each edge of the joint.
- Align pieces together and fasten with rivets at 50 mm centres.
Clause:
014_012_000_000_000_000_000_000_000
Clause Number:
14.12
/cop/installation/sealing-and-joining
Revision Category:
2 - Editing and rearrangement
- Log in to post comments